Author Topic: Please help! Dr Martin's isn't drying..  (Read 322 times)

Offline flomade

  • Freshman Member
  • *
  • Posts: 44
  • Karma: 1
    • View Profile
Please help! Dr Martin's isn't drying..
« on: September 23, 2017, 08:26:15 AM »
I have been working on pieces writing epitaphs on cabinet cards, and am using dr Martins bleed proof white for the first time. I Love it. The only problem is that it isn't drying. Days later I can wipe the ink right off. Any advice on how to prevent this? I realize the surface of the cards are glossier, but my walnut ink sets well on them.

Any advice would be most appreciated!

Kindly,
flo
« Last Edit: September 23, 2017, 08:44:03 AM by flomade »

Offline AnasaziWrites

  • Super Hero Member
  • ******
  • Posts: 1553
  • Karma: 106
  • Ad astra, per aspera
    • View Profile
Re: Please help! Dr Martin's isn't drying..
« Reply #1 on: September 23, 2017, 11:06:34 AM »
@flomade

Will the white ink dry on other kinds of paper?
When you say the ink wipes off easily after a few days, is it dried ink that just didn't adhere to the paper or is it still liquid after a few days?
Is it extremely humid where you are working?

If the ink works on other papers, then the ink is okay.
If the ink is dried after a while, but can be easily wiped off because it is not adhering, try spraying the finished piece with a fixative, like Blair Matte Spray Fix.
If the ink is still wet after a couple of days, you could try drying it in a warm oven (say 130 degrees) for an hour or so, or use a blow dryer on gentle/low.  Try this on a sample piece first, to make sure the photo can handle the heat.
If you still can't get the ink to dry, you might try spraying the fixative on the photo before you write on it.

In any case, I would spray the fixative over the BPW any time you use it, to make it waterproof and smudge proof.


Offline Bianca M

  • Hero Member
  • *****
  • Posts: 880
  • Karma: 38
    • View Profile
    • Bianca Mascorro Calligraphy & Art
Re: Please help! Dr Martin's isn't drying..
« Reply #2 on: September 23, 2017, 12:23:24 PM »
I think Mike has covered most solutions, but you may want to check out these past threads from the same issue:

http://theflourishforum.com/forum/index.php?topic=5634.msg69550#msg69550
http://theflourishforum.com/forum/index.php?topic=1036.msg11601#msg11601

It looks like someone had luck after adding gum arabic- but that solution would require a redo for you!

Good luck!